Step 1: Before installing the aluminum skirting board, you must observe whether the ground and wall are flat at the corner. If the unevenness is flattened with a shovel and then cleaned, otherwise the skirting will be bent and uneven after it is installed, and some will not be fully attached to the wall. Will leave unsightly gaps.

    Step 2: Saw a section of 15 cm long aluminum alloy skirting line, clip the clip to the slot on the back, and make a mark on the hole of the clip against the wall.

    Before drilling, observe the wiring direction of the water and electricity to prevent mistakes. The interval between drilling holes should not be too large, generally, about 40cm is more appropriate.

    Use a special tool to drill holes in the wall, and then use plastic nails to drive into the newly drilled holes. Fasten the clip to the wall with screws.

    Step 3: The protruding corners of the wall are called external corners, and the concave corners are called negative corners. To install the yin and yang corners is to use the yin and yang corners to draw the fixed point positions on the wall, then take holes, nail plastic, and then fix the yin and yang corners to the corners with screws.

    Note: Since the pipes of the hydropower project are buried in the wall, the position of the pipes is directly below the switch socket. When drilling holes, the position should be calculated to avoid damage.

    Step 4: Use a tape measure to measure the size distance of each section, cut out the corresponding size with a cutting machine, and clip it on the corresponding buckle. The length of each aluminum alloy skirting line is 3 meters. When the wall exceeds the length of the skirting line, a clip should be installed in the middle of the interface, so as to ensure the smoothness of the skirting line.

     The skirting line should be completely close to the wall, leaving no gaps, it is more beautiful, especially the corners. The flatness of the wall should be tested before installation.